Altigen AltiContact Manager Version 5.0 Administration Manual page 420

ACM Admin settings. Also, after the IP Phone is successfully
registered with AltiContact Manager, the IP phone will
overwrite the AltiContact Manager IP address and network-
related settings on the server.
Important: When updating the Alti-IP 600 phone's firmware, it is
recommended that administrators perform any updates after
normal business hours or when the IP phone is not in use. If the
Alti-IP 600 phone is in use during an update, the call will be
disconnected.
Apply To Button
The Apply To button works with the following parameters: General,
H.323, TFTP (Server field only; Reset IP Phone and Boot Download
options cannot be applied to multiple extensions), Display Workgroup
Status and Debug.
Copy From Button
The Copy From button allows you to copy Function Key settings from
one Alti-IP 600 phone setting to another. No other settings are carried over.
IP Extension Log In/Log Out
The feature codes #26 (Extension Log Out) and #27 (Extension Log In) are
available on the Alti-IP 600. When the Alti-IP 600 is logged in using #27
+ ENTER, the LCD will display the extension number. The Alti-IP 600
must be onhook for #26 and #27 to work.
Dialing an IP Number Directly from the Alti-IP 600
To dial an IP number directly from the Alti-IP 600 phone set, enter the IP
address using the * key to enter periods followed by the # key.
Notes:
• This only works when the Alti-IP 600 is operating in basic mode.
• If the Alti-IP 600 is configured for a public IP address, you can call
other public IP address devices.
• If the Alti-IP 600 is configured for a private IP address, you can call
other private IP address devices that you can "see" or that are on your
subnet.
17-4 AltiContact Manager Administration Manual