Flex-Attach Virtual-Pwwn Interface - Cisco MDS 9124 - Fabric Switch Reference

Chapter 8 F Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

flex-attach virtual-pwwn interface

To set the user-specific FlexAttach virtual port WWN (pWWN) on an interface, use the flex-attach
virtual-pwwn interface command. To disable the virtual pWWN, use the no form of the command.
Syntax Description
vpwwn
interface
vsan vsan
Defaults None.
Command Modes Configuration mode
Command History Release
3.3(1a)
Usage Guidelines None.
Examples The following example shows how to set the user-specific virtual pWWN on an interface.
switch# config
Enter configuration commands, one per line.
switch# (config) flex-attach virtual-pwwn 20:04:00:a0:b8:16:92:18 interface fc 1/1
Related Commands Command
flex-attach
virtual-pwwn auto
OL-16217-01, Cisco MDS SAN-OS Release 3.x
flex-attach virtual-pwwn vpwwn interface interface [vsan vsan]
no flex-attach virtual-pwwn vpwwn interface interface [vsan vsan]
Specifies the virtual pWWN chosen by the user.
Specifies the interface on which the FlexAttach virtual port has to be
enabled.
Note
Specifies the VSAN on which FlexAttach should be enabled.
Modification
This command was introduced.
Description
Enables the FlexAttach virtual pWWN on a specific interface.
The interface must be in the shut state.
End with CNTL/Z.
Cisco MDS 9000 Family Command Reference
flex-attach virtual-pwwn interface
8-79