Channel-Group - Cisco MDS 9124 - Fabric Switch Reference

Chapter 4 C Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

channel-group

To add a port to a PortChannel group, use the channel-group command. To remove a port, use the no
form of the command.
Syntax Description
port-channel-number
force
auto
Defaults
None.
Command Modes Interface configuration submode.
Command History Release
3.0(1)
Usage Guidelines
None.
Examples The following example shows how to enable auto creation of a PortChannel.
switch# config terminal
switch(config)# interface fc3/9
switch(config-if)# channel-group auto
Related Commands Command
show interface port-channel
OL-16217-01, Cisco MDS SAN-OS Release 3.x
channel-group {port-channel-number force | auto}
no channel-group {port-channel-number force | auto}
Specifies the PortChannel number. The range is 1 to 256.
Specifies using the force option to add a port.
Enables auto creation of a PortChannel.
Modification
This command was introduced.
Description
Displays PortChannel interface information.
Cisco MDS 9000 Family Command Reference
channel-group
4-21