Fcc Priority - Cisco MDS 9124 - Fabric Switch Reference

Chapter 8 F Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

fcc priority

To assign the FCC priority to the entire switch, use the fcc priority command in configuration mode. To
revert to the default, use the no form of the command.
Syntax Description
number
Defaults The default priority is 4.
Command Modes
Configuration mode.
Command History Release
1.0(2)
Usage Guidelines FCC reduces the congestion in the traffic without interfering with standard Fibre Channel protocol.
This command is not supported on the Cisco MDS 9124 switch, the Cisco Fabric Switch for HP c-Class
Note
BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter.
Examples
The following example shows how to configure the FCC priority threshold as 2.
switch# config terminal
switch(config)# fcc priority 2
Related Commands Command
show fcc
OL-16217-01, Cisco MDS SAN-OS Release 3.x
fcc priority number
no fcc priority number
The FCC priority threshold. The range is 0 to 7, where 0 is the lowest priority
and 7 the highest priority.
Modification
This command was introduced.
Description
Displays FCC settings.
Cisco MDS 9000 Family Command Reference
fcc priority
8-17