Cisco MDS 9124 - Fabric Switch Reference page 573

Chapter 8 F Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command History Release
1.0(2)
Usage Guidelines
This command configures FSPF on VSANs globally.
For the commands issued in FSPF configuration mode, you do not have to specify the VSAN number
every time. This prevents configuration errors that might result from specifying the wrong VSAN
number for these commands.
Examples The following example configures FSPF globally in VSAN 1, deletes the FSPF configured in VSAN 3,
disables FSPF in VSAN 5, and enables FSPF in VSAN 7.
switch
switch(config)
switch(config)# fspf config vsan 1
switch-config-(fspf-config)# spf static
switch-config-(fspf-config)# exit
switch(config)#
switch(config)# no fspf config vsan 3
switch(config)#
Related Commands Command
show fspf interface
fspf enable
fspf cost
fspf hello-interval
fspf passive
fspf retrasmit
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Modification
This command was introduced.
#
# config terminal
#
#
Description
Displays information for each selected interface.
Enables FSPF routing protocol in the specified VSAN (from the
switch(config-if)#
Configures the cost for the selected interface in the specified VSAN (from the
switch(config-if)#
Specifies the hello message interval to verify the health of a link in the VSAN
(from the
Disables the FSPF protocol for the specified interface in the specified VSAN
(from the
Specifies the retransmit time interval for unacknowledged link state updates in
specified VSAN (from the
prompt).
prompt).
prompt).
switch(config-if)#
prompt).
switch(config-if)#
switch(config-if)#
Cisco MDS 9000 Family Command Reference
fspf config vsan
prompt).
8-83