Rmon Hcalarm - Cisco MDS 9124 - Fabric Switch Reference

Chapter 20 R Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

rmon hcalarm

To configure a 64-bit remote monitoring (RMON) high-capacity alarm (hcalarm), use the rmon hcalarm
command in configuration mode. To delete an rmon hcalarm, use the no form of the command.
Syntax Description alarm-number
mib-object
sample-interval
absolute
delta
rising-threshold-high
value
rising-threshold-low
value
rising-event
falling-threshold-high
value
falling-threshold-low
value
falling-event
owner alarm-owner
Defaults 64-bit alarms.
Command Modes Configuration mode
Command History Release
3.0(1)
OL-16217-01, Cisco MDS SAN-OS Release 3.x
rmon hcalarm alarm-number mib-object sample-interval {absolute | delta}
{rising-threshold-high value rising-threshold-low value [rising-event]
[falling-threshold-high value falling-threshold-low value [falling-event]] |
falling-threshold-high value falling-threshold-low value [falling-event]}
[owner alarm-owner]
no rmon hcalarm alarm-number
Specifies the RMON hcalarm number. The range is 1 to 65535.
Specifies the MIB object to monitor. Maximum length is 80 characters.
Note
Specifies the sample interval in seconds. The range is 1 to 65535.
Tests each sample directly.
Tests the difference (delta) between the current and previous sample.
Configures the upper 32 bits of the 64-bit rising threshold value. The range
is 0 to 4294967295.
Configures the lower 32 bits of the 64-bit rising threshold value. The range
is 0 to 4294967295.
(Optional) Specifies the event to trigger on rising threshold crossing. The
range is 1 to 65535.
Configures the upper 32 bits of the 64-bit falling threshold value. The range
is 0 to 4294967295.
Configures the lower 32 bits of the 64-bit falling threshold value. The range
is 0 to 4294967295.
(Optional) Specifies the event to trigger on falling threshold crossing. The
range is 0 to 65535.
(Optional) Specifies an owner for the alarm. Maximum size is 80 characters.
Modification
This command was introduced.
The MIB object identifier must be fully numbered, dotted-decimal
notation, not the text string description.
Cisco MDS 9000 Family Command Reference
rmon hcalarm
20-29