Interface Sme (Cisco Sme Cluster Node Configuration Submode) - Cisco MDS 9124 - Fabric Switch Reference

interface sme (Cisco SME cluster node configuration submode)

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
interface sme (Cisco SME cluster node configuration submode)
To add Cisco SME interface from a local or a remote switch to a cluster, use the interface sme command.
To delete the interface, use the no form of the command.
Syntax Description
slot
port
force
Defaults
Disabled.
Command Modes Cisco SME cluster node configuration submode.
Command History Release
3.2(2)
Usage Guidelines
You have to first configure a node using the fabric-membership command before this command can be
executed.
To use this command, clustering must be enabled using the cluster enable command and Cisco SME
services must be activated using the sme enable command.
To delete the Cisco SME interface, first remove the switch from the cluster. Use the no sme cluster
command to remove the switch from the cluster and then use the no interface command to delete the
interface.
Examples The following example specifies the fabric to which the node belongs and then adds the Cisco SME
interface (4/1) from a local switch using the force option:
switch# config t
switch(config)# sme cluster clustername1
switch(config-sme-cl)# node local
switch(config-sme-cl-node)# fabric-membership f1
switch(config-sme-cl-node)# interface sme 4/1 fabric sw-xyz
The following example specifies the fabric to which the node belongs and then adds the Cisco SME
interface (4/1) from a remote switch using the force option:
switch# config t
switch(config)# sme cluster clustername1
switch(config-sme-cl)# node 171.71.23.33
switch(config-sme-cl-node)# fabric-membership f1
switch(config-sme-cl-node)# interface sme 4/1 fabric sw-xyz
Cisco MDS 9000 Family Command Reference
11-38
interface sme (slot/port) [force]
no interface sme (slot/port) [force]
Identifies the MPS-18/4 module slot.
Identifies the Cisco SME port.
Forcibly clears the previous interface context in the interface.
Modification
This command was introduced.
Chapter 11
OL-16217-01, Cisco MDS SAN-OS Release 3.x
I Commands