Interface Iscsi - Cisco MDS 9124 - Fabric Switch Reference

interface iscsi

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
interface iscsi
To configure an iSCSI interface, use the interface iscsi command. To revert to default values, use the no
form of the command.
Syntax Description slot/port
mode
pass-thru
store-and-forward
cut-thru
tcp qos value
Defaults Disabled.
The TCP QoS default is 0.
The forwarding mode default is store-and-forward.
Command Modes Configuration mode.
Command History Release
1.3(1)
2.1(1)
Usage Guidelines
To configure iSCSI interface, enable iSCSI using the iscsi enable command.
You can specify a range of interfaces by issuing a command with the following example format:
interface iscsi space fc1/1space-space5space,spacefc2/5space-space7
Examples The following example enables the iSCSI feature.
switch# config t
switch(config)# iscsi enable
Cisco MDS 9000 Family Command Reference
11-32
interface iscsi slot/port
mode {pass-thru | store-and-forward}
tcp qos value
interface iscsi slot/port
no mode {pass-thru | store-and-forward | cut-thru}
no tcp qos value
no interface iscsi slot/port
Specifies a slot number and port number.
Configures a forwarding mode.
Forwards one frame at a time.
Forwards data in one assembled unit (default).
Forwards one frame at a time without waiting for the exchange to complete.
Configures the differentiated services code point (DSCP)
value to apply to all outgoing IP packets. The range is 0 to 63.
Modification
This command was introduced.
Added the cut-thru option for the mode subcommand.
Chapter 11
OL-16217-01, Cisco MDS SAN-OS Release 3.x
I Commands