Qos Policy-Map - Cisco MDS 9124 - Fabric Switch Reference

qos policy-map

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
qos policy-map
To specify the class of service, use the qos policy-map command in configuration mode. To remove a
previously configured class, use the no form of the command.
Syntax Description
policy-name
Defaults Disabled.
Command Modes
Configuration mode.
Command History Release
1.3(1)
Usage Guidelines You can access this command only if you enable the QoS data traffic feature using the qos enable
command.
As an alternative, you can map a classmap to a Differentiated Services Code Point (DSCP).The DSCP
is an indicator of the service level for a specified frame. The DSCP value ranges from 0 to 63. A dscp
value of 46 is disallowed.
Examples
The following example creates a policy map called MyPolicy and places you in the policy-map submode.
switch(config)# qos policy-map MyPolicy
switch(config-pmap)#
Related Commands Command
qos enable
show qos
Cisco MDS 9000 Family Command Reference
19-6
qos policy-map policy-name
no qos policy-map policy-name
Modification
This command was introduced.
Description
Enables the QoS data traffic feature on the switch.
Displays configured QoS information.
Specifies a policy map name. Maximum length is 63 alphanumeric
characters.
Chapter 19 Q Commands
OL-16217-01 Cisco MDS SAN-OS Release 3.x