Interface Sme - Cisco MDS 9124 - Fabric Switch Reference

Chapter 11 I Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

interface sme

To configure the Cisco SME interface on a switch, use the interface sme command. To remove the
interface, use the no form of the command,
Syntax Description
slot
port
Defaults Disabled.
Command Modes Configuration mode.
Command History Release
3.2(2)
Usage Guidelines
To use this command, clustering must be enabled using the cluster enable command and Cisco SME
services must be activated using the sme enable command.
Once you have configured the interface, use the no shutdown command to enable the interface.
To delete the Cisco SME interface, you must first remove the switch from the cluster. Use the no sme
cluster command to remove the switch from the cluster and then use the no interface command to delete
the interface.
The interface commands are available in the (config-if) submode.
Examples
The following example configures and enables the Cisco SME interface on the MPS-18/4 module slot
and the default Cisco SME port:
switch# config terminal
switch(config)# interface sme 3/1
switch(config-if)# no shutdown
Related Commands Command
shutdown
show interface sme
OL-16217-01, Cisco MDS SAN-OS Release 3.x
interface sme slot /port
no interface sme slot /port
Identifies the number of the MPS-18/4 module slot.
Identifies the number of the Cisco SME port.
Modification
This command was introduced.
Description
Enables or disables an interface.
Displays interface information.
Cisco MDS 9000 Family Command Reference
interface sme
11-37