Islb Zoneset Activate - Cisco MDS 9124 - Fabric Switch Reference

Chapter 11 I Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

islb zoneset activate

To activate iSCSI server load balancing (iSLB) auto zones, use the islb zoneset activate command.
Syntax Description
This command has no arguments or keywords.
Defaults None.
Command Modes Configuration mode.
Command History Release
3.0(1)
Usage Guidelines
Auto-zoning of the initiator with the initiator targets is enabled by default.
A zone set must be active for a VSAN for auto-zones to be created in that VSAN. The zoneset activate
command creates auto-zones only if at least one other change has been made to the zone set.
Examples The following example activates an iSLB auto zone.
switch# config t
switch(config)# islb zoneset activate
Related Commands Command
show zoneset active
OL-16217-01, Cisco MDS SAN-OS Release 3.x
islb zoneset activate
Modification
This command was introduced.
Description
Displays active zone sets.
Cisco MDS 9000 Family Command Reference
islb zoneset activate
11-113