Ip Address (Interface Configuration) - Cisco MDS 9124 - Fabric Switch Reference

Chapter 11 I Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

ip address (interface configuration)

To assign an IP address to a Gigabit Ethernet interface, use the ip address command in interface
configuration submode. To remove the IP address, us the no form of the command.
Syntax Description
address
netmask
Defaults None.
Command Modes Interface configuration submode.
Command History Release
1.1(2)
Usage Guidelines
None.
Examples The following example assigns an IP address to a Gigabit Ethernet interface.
switch# config terminal
switch(config)# interface gigabitethernet 1/2
switch(config-profile)# ip address 10.5.1.1 255.255.0.0
Related Commands Command
show fcip profile
interface fcip
interface_number
use-profile profile-id
show interface fcip
OL-16217-01, Cisco MDS SAN-OS Release 3.x
ip address address netmask
no ip address address netmask
Specifies the IP address.
Specifies the network mask.
Modification
This command was introduced.
Description
Displays information about the FCIP profile.
Configures the interface using an existing profile ID from 1 to 255.
Displays an interface configuration for a specified FCIP interface.
ip address (interface configuration)
Cisco MDS 9000 Family Command Reference
11-47