Span Session Source Interface - Cisco MDS 9124 - Fabric Switch Reference

Cisco mds 9000 family command reference - cisco mds san-os release 3.0(1) through 3.3(1a) (ol-16217-01, april 2008)
Hide thumbs Also See for Cisco MDS 9124 - Fabric Switch:
Table of Contents

Advertisement

span session source interface

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
span session source interface
To configure the SPAN traffic in both ingress (rx) and egress (tx) directions, use the span session source
interface command in Configuration mode.
Syntax Description
session-id
interface type
Defaults
None.
Command Modes
Configuration mode
Command History
Release
1.0(x)
3.3(1a)
Usage Guidelines
None.
Examples
The following example shows how to configure the SPAN traffic in both ingress and egress directions.
switch#config
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# span session 1
switch(config-span)# source interface fc 1/5 rx
switch(config-span)# source interface fc 1/5 tx
switch(config-span)# destination interface fc 1/5
Related Commands
Command
show span session
Cisco MDS 9000 Family Command Reference
21-52
span session session-id source interface interface type
Specifies the SPAN session ID.
Specifies the destination interface mapped to a Fiber Channel or FC tunnel.
Modification
This command was introduced.
Enabled SPAN traffic in both ingress (rx) and egress (tx) directions for
Generation 2 Fabric Switches.
Description
Displays specific information about a Switched Port Analyzer (SPAN)
session.
Chapter 21
OL-16217-01, Cisco MDS SAN-OS Release 3.x
S Commands

Advertisement

Table of Contents
loading

Table of Contents