Resetting The Valueloader; Changing The Scsi Id - Freecom VALUELOADER DLT User Manual

ValueLoader Administration
Configuring the ValueLoader
Resetting the
3
ValueLoader
Changing the SCSI
3
ID
40 ValueLoader DLT VS80/DLT VS160 Tape Autoloader User Manual
• ValueLoader Operating Modes
• Updating firmware
To access the Configuration menu from the Home screen or main
menu, press the
[+]
the top line of the LCD screen. Press the
or to access the available options. Press the
[–]
execute the displayed menu option.
This option resets the ValueLoader robotics and the tape drive
within the ValueLoader, forces a new cartridge inventory, and
clears any current error condition.
This option is primarily used if the ValueLoader is in an
Note:
error state.
To access this option, follow these steps:
From the Home screen or main menu, press the
1
until "Configuration" appears on the top line of the LCD
screen.
Press to select.
2 [Enter]
Press the or
3 [+] [–]
screen.
Press the
4 [Enter]
After initialization, the ValueLoader returns to normal operation
and displays the Home screen.
This option changes the SCSI ID the ValueLoader uses. The
ValueLoader operates as a single SCSI device with two separate
SCSI Logical Unit Numbers (LUNs): one LUN (0) is for the tape
drive, the other (1) is for the ValueLoader robotics.
The default SCSI ID is 5. You should only need to change the SCSI
ID if there are other devices on the SCSI bus with the same SCSI
ID.
or button until "Configuration" appears on
[–]
button until "Reset" appears on the LCD
button to reset the ValueLoader.
button and then
[Enter]
button to
[Enter]
or
[+] [–]
[+]
button