Step 2: Check The Drive's Scsi Id - Freecom LTO 460I Manual

Ultrium generation 2 internal tape drives

Hide thumbs Also See for LTO 460I:

Table of Contents

Step 2: Check the drive's SCSI ID

Your Ultrium Generation 2 drive is shipped with a default SCSI ID of 3, but it can be

assigned any unused ID between 0 and 15. Do not use SCSI ID 7, which is reserved for the

SCSI controller, or SCSI ID 0, which is typically assigned to the boot disk.

Determine whether you need to change the SCSI ID from the default of 3.

Caution Static electricity can damage electronic components. Always wear an antistatic wriststrap if

possible. If not, to equalize the electromagnetic charges, touch a bare metal part of the

computer (such as the back plate) before you remove the tape drive from its bag.

Change the tape drive's SCSI ID, if necessary.

The SCSI ID is set using jumpers on a set of pins at the rear of the drive. Move the jumpers

carefully to the pattern corresponding to the ID you want, see Figure 2.

9 9

Table of Contents