Just Size Printing; Having Incoming Messages Printed On Paper From The Bypass Tray - Ricoh Aficio 2022 User Manual

Reception Features

Just size printing

If you turn this function on and no pa-
per tray is stocked with paper of a
suitable size to print a received docu-
ment, a message will appear on the
display prompting you to load paper
of the required size. When you have
loaded new paper, you can then print
the message.
Two messages can appear:
• Paper Tray
5
• Bypass Tray
Limitation
❒ If the paper tray is pulled out or
the machine runs out of the speci-
fied size of paper, the message will
not be printed. Be sure the paper
tray is inserted.
❒ The action that follows pressing
[Exit] varies depending on the sta-
tus of the machine when the mes-
sage occurred.
102
• If any received documents or re-
ports were being printed auto-
m a t i c a l l y ,
automatically continues print-
ing from where it left off.
• If any documents or reports
were being printed manually,
the printer does not resume
printing. Perform the operation
from the beginning again.
Note
❒ You can turn this function on or off
with the User Parameters. See
p.158 "User Parameters" (switch
05, bit 5).
Having Incoming Messages
Printed on Paper from the
Bypass Tray
You can have messages sent from
Specified Senders printed on paper
from the bypass tray. This is useful if
you need messages printed on a size
of paper not stocked in the paper
tray(s).
You can load a maximum of 100
sheets of standard paper in the by-
pass tray.
Note
❒ Before you can use this function,
you need to turn on Authorized
Reception (Initial Setup Reception
Mode settings), program the Spec-
ified Senders (Key Operator Set-
tings) along with the paper. See
p.144 "Reception Settings". See
p.163 "Special Senders to Treat
Differently".
❒ The print area is determined by the
optional expansion memory, reso-
lution, and the vertical length of
the originals.
t h e p r i n t e r