Windows Configuration; Configuring Tcp/Ip; Configuring A Windows 95/98/Me Computer; Configuring A Windows 2000 Computer - Ricoh Aficio 2022 User Manual

4. Windows Configuration

Configuring TCP/IP

This describes how to configure Win-
dows for TCP/IP and IPP.
Configuring a Windows
95/98/Me Computer
Follow the procedure below to con-
figure a Windows 95/98/Me compu-
ter to use TCP/IP.
A A A A
Open [Control Panel], and then
double-click the Network icon.
Make sure [TCP/IP] is listed in the
[The following network components
are installed] box on the [Configura-
tion] tab.
Note
❒ Under Windows Me, if you
want to use IEEE 1394 (IP over
1394) interface, make sure TCP/
IP is bound to the IEEE 1394
adaptor being used. The follow-
ing message appears:
TCP/ IP -> (IEEE 1394
adaptor in use)
❒ If TCP/IP is not installed, click
[Add] on the [Configuration] tab to
install it. For more information
about installing TCP/IP, see
Windows 95/98/Me Help.
B B B B
Configure TCP/IP using the ap-
propriate IP address, subnet
mask, and other settings.
Check with the network adminis-
trator that the settings are correct.
Configuring a Windows 2000
Computer
Follow the procedure below to con-
figure a Windows 2000 computer to
use TCP/IP.
A A A A
On the [Start] menu, point to [Set-
tings], and then click [Network and
Dial-up Connections].
B B B B
Double-click [Local Area Connec-
tion]. On the [General] tab, click
[Properties].
C C C C
Make sure
(TCP/IP)] is selected in the [Compo-
nents checked are used by this connec-
tion] box on the [General] tab.
Note
❒ Select TCP/IP if it is not already
selected.
❒ If TCP/IP is not installed, click
[Install] on the [General] tab to in-
stall it. For more information
about installing TCP/IP, see
Windows 2000 Help.
D D D D
Configure TCP/IP using the ap-
propriate IP address, subnet
mask, and other settings.
Check with the network adminis-
trator that the settings are correct.
[Internet Protocol
47