Troubleshooting; Error & Status Messages On The Display Panel - Ricoh Aficio 2022 User Manual

Error & Status Messages on the Display
Panel
This section describes the principal messages that appear on the panel display.
If a message not described here appears, act according to the message.
Reference
Before turning the main power off, see 'Turning On the Power', General Set-
tings Guide.
❖ ❖ ❖ ❖ Status messages
Message
Hex Dump Mode
Offline
Please wait.
Printing...
Ready
Resetting job...
Waiting...
❖ ❖ ❖ ❖ Alert messages
Messages/Second messages
Cannot connect with the
wireless card.
Close duplex unit cover.
Collate has been cancelled.

4. Troubleshooting

In Hex Dump mode, the machine receives data in hexadecimal
format. Turn off the machine after printing, and then turn back
on.
The machine is offline. To start printing, switch the machine
online by pressing [Offline] on the display panel.
The machine is preparing the development unit. Wait a while.
The machine is printing. Wait a while.
This is the default ready message. The machine is ready for
use. No action is required.
The machine is resetting the print job. Wait until "Ready" ap-
pears on the display panel.
The machine is waiting for the next data to print. Wait a while.
Causes
The IEEE 802.11b card may
have come off, or an error may
have occurred in the IEEE
802.11b card.
The cover of the duplex unit is
open.
The collate print function has
been canceled.
Status
Solutions
Turn off the main power
switch, and check the card is
installed correctly. If the mes-
sage appears again, contact
your sales or service repre-
sentative.
Close the cover of the duplex
unit.
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
25