Omron 3G3MV-PDRT2 User Manual page 349

Appendices
Code Display
14 EF6 External fault (Terminal 6)
15 EF7 External fault (Terminal 7)
16 EF8 External fault (Terminal 8)
17 --- Not used.
18 OS Overspeed
19 DEV Speed deviation
1A PGO PG is disconnected
1B PF Input phase loss
1C LF Output phase loss
1D --- Not used.
1E OPR OPR disconnected
1F ERR EEPROM error
21 to FF --- Not used.
Note 1. Maximum (upper limit) temperature was exceeded.
Note 2. Set temperature was exceeded.
10-7-3 Parameter Reading and Writing
The following tables show the SYSDRIVE 3G3FV Inverter parameters and the corresponding regis-
ter numbers. Write and read the various parameters with "1" as the minimum setting unit. Negative
numbers are expressed as two's complement. If the setting unit is in hexadecimal, there is no need to
convert it.
When writing data in parameters, be sure to send an enter command to enable the written data.
Unless the enter command is transmitted, the data will not be enabled and the Inverter may not start.
Parameters for Initialize Mode
■
Con- Regis- Class 64 (hex)
stant ter num-
In-
ber
stance
(hex)
A1-00 0100 ---
A1-01 0101 01
A1-02 0102 01
A1-03 0103 ---
A1-04 0104 ---
A1-05 0105 ---
A2-01 0106 to ---
to 0125
A2-32
Content
Name
At-
tribute
--- Display Language
01 Access Level
02 Select Control Method
--- Initialize
--- Password
--- Setting the Password
--- User-parameter settings
Chapter 10
Setting Setting Default
range unit setting
0 to 6 1 1
0 to 4 1 2
0 to 3 1 2
0 to 3330 1 0
0 to 9999 1 0
0 to 9999 1 0
0180 to --- ---
050C
Set the
register
numbers
for b1-01
to o2-08.
Write
during
opera-
tion
Yes
Yes
No
No
No
No
No
10-91