Switching The Remote I/O Function; Switching With The Default Connection Path (Slave) - Omron 3G3MV-PDRT2 User Manual

Remote I/O Functions
5-2

Switching the Remote I/O Function

To use remote I/O operations other than the default setting (standard remote I/O), it is necessary to
switch the remote I/O operation. There are two ways to switch the remote I/O function with the
DeviceNet Configurator.
• Open the Slave's Edit Device Parameters Window in the Configurator, select the desired remote I/O function
from the pull-down list (default connection path setting), and download the settings.
• Open the Master's Edit Device Parameters Window in the Configurator and set the connection path in the
Advanced setting Window.

5-2-1 Switching with the Default Connection Path (Slave)

Use the following procedure to switch the Slave's remote I/O function with the Configurator.
■ Procedure
1.Select the desired Slave's icon in the Configurator, right click, and select Parameters/Edit from
the popup menu to open the Edit Device Parameters Window.
2.Click the General Tab and execute the Upload operation to read the Slave's parameters.
3.On the General Tab Page, select the desired remote I/O function pattern from the Default Connec-
tion Path List.
4.Execute the Download operation. (The Download operation downloads all of the data together, in-
cluding the Inverter's parameters and settings other than those on the General Tab Page.)
5.Click the Reset Button to reset the Slave and enable the new setting.
Chapter 5
Default Connection Path
5-5