Omron 3G3MV-PDRT2 User Manual page 193

Configurator Settings
Setting Method 1: Inverter Parameters Tab Page in the Edit Device
■
Parameters Window
1.Click the Inverter Parameters Tab in the Edit Device Parameters Window.
2.Select the parameter group to be displayed from the pull-down menu in the Parameter Group field.
Note The displayed parameter groups are classified as shown in the table under Parameter Groups
and Parameters Not Set in Groups on page 7-45. (The parameters that cannot be set depend
on the Inverter series.)
Set the parameters that cannot be set on the Inverter Parameters Tab Page by using the Indi-
vidual Parameters Tab Page. (The main parameters can be set on the Inverter Parameters Tab
Page.) Use a Digital Operator to set the parameters that cannot be set from the Configurator.
3.The parameter number and name will be displayed in the Parameter Name field, and the param-
eter's set value is displayed in the Value field. Double-click the Value field of the parameter to be
changed, and change the set value.
Note 1. Use either of the following two methods to set the parameter's set value.
• Select the set value from the pull-down menu.
• Input the numerical value.
Note 2. The details of the selected parameter are displayed in the Help Area. When setting the pa-
rameter, refer to the default value of the selected parameter that is displayed in the Default
Area. For further details on the parameters, refer to the operation manual of the Inverter be-
ing used.
Inverter Parameters Tab Page
in the Edit Device Parameters
Window
Select the parameter group.
Chapter 7
7-43