Omron 3G3MV-PDRT2 User Manual page 141

Message Communications
Instance Attribute
01 09 Inverter Ready
0A Fault
0B Alarm (minor
fault)
0C Fault Reset
0D Fault code
0F Control From
Net
Run signal input
status
(See note 2.)
10 DeviceNet Fault
mode
(See note 3.)
11 Force Fault/Trip
Communica-
tions external
fault input
12 Force Status
Communica-
tions external
fault input status
Note 1. The following table shows the status of remote I/O output signals and operation indicated by
the content of Attribute 06 (State, i.e., Inverter status).
Setting
00 hex Vendor specific
01 hex Startup: Preparation not complete (setting con-
stants)
02 hex Not ready: Stopped (preparation complete)
03 hex Inverter ready: Stopped (preparation complete) Inverter Ready signal is ON and Dur-
04 hex Enabled: Operating
05 hex Stopping: Decelerating (Operating with both
forward and reverse references equal to 0.)
06 hex Fault_Stop: Operating with fault detected
07 hex Faulted: Fault detected
Note 2. The Net Control and Control From Net functions cannot be changed during running.
Name Content
00: Preparing
Initial processing/ not
drive mode/ fault
01: Inverter ready
Inverter can receive run
command.
00: Normal
01: Fault
00: Normal
01: Alarm (minor fault)
00: Normal status
01: Fault reset
Indicates the contents of
fault that occur. (See the
fault code list on the fol-
lowing page.)
00: Operating with an
n003/b1-02 setting other
than DeviceNet.
01: Operating by
DeviceNet.
00: Stop operation.
01: Continue operation.
02: Maker's specifications
00: Normal operation
01: Communications
external fault input
00: Normal status
01: Communications
external fault detected.
(Inverter stopped with fault
detection.)
Status
Setting range Default
--- 00
--- 00
--- 00
00, 01 00
--- 0000
--- 00
3G3MV: 00, 3G3MV:
01 00
3G3RV: --- 3G3RV:
3G3FV: --- 02
3G3FV:
02
00, 01 00
--- 00
Condition
A condition other than the ones
below.
Inverter Ready signal is OFF.
Inverter Ready signal is ON and Dur-
ing Run signal is OFF.
ing Run signal is OFF.
During Run signal (control I/O) is
ON.
Ctrl. From Net is ON, During For-
ward Run is OFF, During Reverse
Run is OFF, and During Run is ON.
Alarm signal is ON.
Fault signal is ON.
Chapter 6
Read Write Size
Yes No Byte
Yes No Byte
Yes No Byte
Yes Yes Byte
Yes No Word
Yes No Byte
Yes Yes Byte
Yes Yes Byte
Yes No Byte
6-11