Omron 3G3MV-PDRT2 User Manual page 274

Appendices
Instance Attribute
01 11 Force Fault/Trip
Communica-
tions external
fault input
12 Force Status
Communica-
tions external
fault input status
Note 1. The following table shows the status of remote I/O output signals and operation indicated by
the content of Attribute 06 (State, i.e., Inverter status).
Setting
00 hex Vendor specific
01 hex Startup: Preparation not complete (setting con-
stants)
02 hex Not ready: Stopped (preparation complete)
03 hex Inverter ready: Stopped (preparation complete) Inverter Ready signal is ON and Dur-
04 hex Enabled: Operating
05 hex Stopping: Decelerating (Operating with both for-
ward and reverse references equal to 0.)
06 hex Fault_Stop: Operating with fault detected
07 hex Faulted: Fault detected
Note 2. The Net Control and Control From Net functions cannot be changed during running.
Note 3. A DeviceNet Fault mode can be set from communications in the 3G3MV only; it cannot be
changed from communications in the 3G3RV or 3G3FV. Set the fault mode in the Inverter's
parameters.
● Fault Codes
DeviceNet error code
0000
2120
2130
2200
2220
2221
2222
2300
3130
3210
3220
3222
4200
10-16
Name Content
00: Normal operation
01: Communications
external fault input
00: Normal status
01: Communications
external fault detected.
(Inverter stopped with fault
detection.)
Status
Operator display
--- Inverter normal
GF Ground fault
SC Short circuit
OL2 Inverter overload
OL1 Motor overload
OL3 Overtorque detection 1
OL4 Overtorque detection 2
OC Overcurrent
PF Input phase loss
LF Output phase loss
OV Main circuit overvoltage
UV1 Undervoltage (main)
UV3 Undervoltage (MC)
OH Overheat
Setting range Default
00, 01 00
--- 00
Condition
A condition other than the ones
below.
Inverter Ready signal is OFF.
Inverter Ready signal is ON and Dur-
ing Run signal is OFF.
ing Run signal is OFF.
During Run signal (control I/O) is
ON.
Ctrl. From Net is ON, During Forward
Run is OFF, During Reverse Run is
OFF, and During Run is ON.
Alarm signal is ON.
Fault signal is ON.
Meaning
Chapter 10
Read Write Size
Yes Yes Byte
Yes No Byte