Configurator Settings
7-3-6 Warning Torque Tab Page
Use this tab page to make the settings for warning torque detection.
Item
Current 1 (during
Set the threshold used to monitor the current level during
Accel/Decel)
acceleration or deceleration.
Note: When this value is set to 0.0 (A), the current is not
monitored during acceleration or deceleration.
Current 2 (during
Set the threshold used to monitor the current level during
Frequency Agree)
frequency agreement (while operating at constant speed).
Note: When this value is set to 0.0 (A), the current is not
monitored during frequency agreement.
Detection Filter
Select the
(Low) to Sensitivity 5 (High) in the pull-down menu.
Status
Set whether to maintain the ON status in the Unit's Status
Area (Warning Torque Detection Flag) when the current
exceeds either of the thresholds set for Current 1 and Cur-
rent 2.
Details
level of
detection sensitivity from Sensitivity 1
Chapter 7
Reference
7-2-3 Warning Torque
Detection
7-53