Omron 3G3MV-PDRT2 User Manual page 176

Configurator Settings
Monitoring Methods
■
● Using the Monitor Device Window
• Click the Operation Time Tab in the Monitor Device Window.
• The following information will be displayed.
Item
No.
Equipment Name
Response Time
Peak Value
Clear Error Button
Clear Peak Value Button
Note The ON/OFF status of the Operation Time Over Monitor Flag can be checked on the General
Tab Page of the Monitor Device Window. When this flag is ON, Operation Time Over check box
will be selected.
● Using the Maintenance Information Window
• Click the Operation Time Tab in the Maintenance Information Window.
Note The differences between the Operation Time Tab Page in the Monitor Device Window and in
the Maintenance Information Window are as follows:
• The Operation Time field in the Maintenance Information Window shows the value when the
maintenance information was refreshed and not the present value.
7-26
Displays a number indicating the combination of start signals and end signals of
the operating time measurement.
An error icon will be displayed to the left of the number if the response time
exceeds the monitor value.
Displays the name of each device.
Displays the operating time (present value) of each device.
Displays the maximum operating time of each device.
Clears the Operation Time Over Flag in the Unit's Status Area.
Note: This button is enabled when the Status Hold field is selected (to hold sta-
tuses) on the Operation Time Tab Page in the Edit Device Parameters Window.
Clears the operation time peak value to zero.
Note: Select the device for which the peak value is to be cleared, and click the
Peak Value Clear Button to clear the value to zero.
Operation Time Tab Page in the
Monitor Device Window
Details
Chapter 7