Using The Configuration Wizard To Perform Initial Configuration - Nortel Remote Office 9150 Installation And Administration Manual

March 2000
Using the Configuration Wizard to perform
initial configuration
Introduction
The Configuration Wizard option in Configuration Manager allows you to
configure the minimum information needed for establishing communications
between the Remote Office 9150 unit and the MIG RLC at the host site. The
Configuration Wizard does not provide all the configuration settings that are
available in Configuration Manager. By using the Configuration Wizard, the
Remote Office 9150 unit can be up and running within 10 minutes.
You can use the Configuration Wizard in offline mode or while connected and
logged on to the Remote Office 9150 unit (online mode).
What you can configure with the Configuration Wizard
The Configuration Wizard allows you to configure the following:
the Remote Office 9150 unit's IP address, subnet mask, and default
gateway
This information must be valid for your IP network.
Note: If you will not be using the IP network to route calls, you must still
enter this information for administration purposes. If you do not have an IP
network in place, you can use the sample information provided in the
procedure on page 146.
for Voice over IP capability: the IP address for the MIG RLC at the host site
for circuit-switched network capability:
the telephone number of the MIG RLC at the host site
information provided by your ISDN service provider for each ISDN
BRI trunk interface module (telephone numbers, SPIDs, and switch
type)
Ensure you have this information ready before you begin.
Installation and Administration Guide
Installing the Remote Office 9150 unit
141