Nicad Battery Pack; Installing The Battery Pack - Intermec Janus 2010 User Manual

Intermec janus 2010: user guide

Hide thumbs Also See for Janus 2010:

Table of Contents

JANUS 2010 Hand-Held Computer User's Manual

NiCad Battery Pack

The NiCad battery pack is the main power source for the reader. Always keep

a charged battery pack in the reader to preserve the life of the lithium battery.

When you remove a battery pack, insert another charged battery pack in the

reader. If you leave the reader without at least a partially charged battery pack

installed, you will prematurely discharge the lithium battery. For help, see

"Managing Your Battery Power" later in this chapter.

1. Make sure the two yellow battery pack locks on the end of the battery pack

2. Place the two battery pack tabs under the reader's back.

3. Slide the battery pack into the back of the reader until it snaps into place.

4. Push the two battery pack locks up to lock the battery pack in place and

are pushed down in the unlocked position.

engage the interlock switch.

Note: The battery pack locks must be closed to activate the interlock switch and

allow you to use the reader.

Battery pack

tab (2 places)