Intermec Janus 2010 User Manual page 136

JANUS 2010 Hand-Held Computer User's Manual
7. Press
To remove a PC card
1. Make sure the reader is finished writing to the PC card.
2. Press
3. Remove the battery pack. For help, see "Removing the Battery Pack" in
4. Using your thumbs, push the PC card away from the slot until the card is
5. Pull the card up and out of the reader.
6. Install the battery pack. For help, see "Installing the Battery Pack" in
4-10
to turn the reader on. The reader sounds an audible beep tone to
indicate that it recognizes the PC card. For a description of the beep tones,
see "Understanding the Reader's Audio Signals" in Chapter 2.
Note: You may also be prompted to reset the Type I PC card drive when you turn
the reader on. For help, see "Configuring the Reader to Reset the Type I Drive"
earlier in this chapter.
Caution
Do not remove the PC card when the disk write icon is on or you may lose
data.
Conseil
N' enlevez la carte PC quand l'icône d'écriture sur disque est active car vous
pourriez perdre des données.
to turn off the reader.
Chapter 2.
released from the connector inside the reader.
Chapter 2.
PC card
2010U.157