JANUS 2010 Hand-Held Computer User's Manual
5. Pull the card up and out of the reader.
6. When you are ready to close the drive door, line up the three tabs on the
Reader Beeps for PC Cards
Note: When you insert or remove a card from the Type I PC card drive, the reader
beeps after you install the battery pack and turn the reader on.
Configuring, Formatting, and Using PC Cards
By default, the JANUS reader is configured for SRAM cards. You need to
configure the reader and format any other type of PC card before you can use
the card in your reader. The next table shows a brief overview of the process
for each type of PC card. After you scan this overview, you may want to read
the next sections for more details.
4-14
2010U.163
door with the slots in the reader and slide the door into the reader until it
snaps into place.
When you insert or remove a PC card, the JANUS reader beeps to indicate
whether or not the reader recognizes the card. For a description of the
beep tones, see "Understanding the Reader's Audio Signals" in Chapter 2.
If the reader does not sound a beep sequence, remove the card. For the
Type II PC card drives, verify that the reader is turned on. Try inserting
the card again.
PC card
PCMCIA back