Learning The Syntax Of Fta Commands - Intermec Janus 2010 User Manual

JANUS 2010 Hand-Held Computer User's Manual
nugget

Learning the Syntax of FTA Commands

This section describes each FTA command and its syntax. You can abbreviate
the command names as shown in the Syntax column of the next table. Also,
you do not have to capitalize the commands; the commands are not case
sensitive.
FTA Command Descriptions and Syntax
Command Description
CHECKHOST Checks if the host computer
rebooted the reader and is ready
to proceed with the reader as
the server and the host
computer as the client. You can
type this command only from
the reader's DOS command line.
CLOSE
Terminates the connection with
the host computer. You can
abbreviate this command as CL.
EXIT
Terminates the FTA program
and returns you to the DOS
prompt on the reader.
GET
Copies a file from the host
computer to the reader.
HELP
Displays a description of the FTA
commands, syntax, and
parameters.
LUPGRADE Upgrades the reader's drive C
from the reader. Stands for "local
upgrade."
6-46
3 9
helconital
Syntax
ch [port]
where:
port is the COM port for the connection. If you
do not specify a port, the application uses
the first port with an active protocol
handler.
c
e
g hfile [rfile]
where:
hfile is the path and filename of the file to be
transferred from the host computer to
the reader.
rfile is the destination path and filename on
the reader. If you do not specify a rfile
name, the hfile name is used.
h
l file c
where:
file is the path and filename of the image file on
the JANUS reader, and C is the drive to be
updated.