Making The Host Computer The Client - Intermec Janus 2010 User Manual

nugget
To install Interlnk on the host computer from the reader's drive D
1. Connect the reader to the host computer using a 7-wire, null-modem serial
2. Make sure that the MODE command is available on the host computer.
3. On the host computer, make sure that the current working directory is the
4. At the reader's DOS prompt, type this command to copy the Interlnk files

Making the Host Computer the Client

Follow these instructions to run Interlnk with the host computer as the client.
When the host computer is the client, you can access all the reader's drives by
typing commands on the host computer's keyboard.
3 9
helconital
cable and either the communications dock or optical link adapter.
directory where you want to install the Interlnk files.
from the reader's drive D to the host computer:
intersvr /rcopy
Or scan this bar code:
*INTERSVR /ORCOPY*
*INTERSVR /RCOPY*
Follow any instructions displayed on the reader. If the host computer locks
up after you copy the files, reboot the host.
Networking the Reader
Client
Server
2010U.101
6
6-27