Baud Rate - Intermec Janus 2010 User Manual

nugget

Baud Rate

Purpose: Sets the baud rate for the selected communications port on the reader. The
baud rate must match the baud rate of the device (for example, the host
computer) that the reader is communicating with.
For Polling Mode D protocol, you must set the baud rate to 1200 or higher. For
Multi-Drop protocol, you must set the baud rate to 2400 or higher.
Note: You must select the communications port and protocol before you set the
parameters to define that protocol. For help, see the "Communications Protocol,
Configure" command later in this chapter.
Default: 9600 baud
IAdata
Syntax:
Acceptable values for data are:
0
1
2
3
4
5
6
7 19200 baud
8 38400 baud
Scan: One of these bar codes:
110 Baud
*$+IA0*
*$+IA0*
600 Baud
*$+IA2*
*$+IA2*
2400 Baud
*$+IA4*
*$+IA4*
3 9
helconital
110 baud
300 baud
600 baud
1200 baud
2400 baud
4800 baud
9600 baud
Configuration Command Reference
300 Baud
*$+IA1*
*$+IA1*
1200 Baud
*$+IA3*
*$+IA3*
4800 Baud
*$+IA5*
*$+IA5*
12
12-11