Intermec Janus 2010 User Manual page 70

Intermec janus 2010: user guide
Hide thumbs Also See for Janus 2010:
Table of Contents

Advertisement

JANUS 2010 Hand-Held Computer User's Manual
You can use Control mode to change the display parameters at the DOS
prompt or when you are running an application. You should only change the
scroll line at the DOS prompt.
To use Control mode
1. To enter Control mode, press and hold
2. Press any of these key sequences to adjust the display.
3. Press
Note: The display parameters you set in Control mode are reset to the default
configuration value when you warm boot the reader. Display Contrast is reset only
when you cold boot the reader.
2-28
f
a
keys. The
and
icons appear on the reader's display.
h
Press
To Adjust the Display
j
Make the display contrast darker.
e
Make the display contrast lighter.
8
Turns the display backlight on or off.
6
Change the scroll line to line 8.
5
Change the scroll line to line 16.
3
Change the scroll line to line 25.
9
Change the characters to normal height.
2
Change the characters to double height.
1
Change the viewport to automatically follow the cursor.
g
Change the viewport so that you must manually move it.
i
Make the beep volume quieter.
Make the beep volume louder.
d
to exit Control mode. The
reader's display.
f
a
, press
, and then release both
f
a
and
icons disappear from the

Advertisement

Table of Contents
loading

Table of Contents