Using Dos Commands - Intermec Janus 2010 User Manual

Intermec janus 2010: user guide

Hide thumbs Also See for Janus 2010:

Table of Contents

JANUS 2010 Hand-Held Computer User's Manual

Using DOS Commands

The JANUS reader uses the DOS operating system, and you can use DOS

commands on the reader just as you do on a PC. From the DOS prompt, you

type a DOS command and press

Or you can create and scan bar code labels that contain DOS commands:

For help using DOS commands, see any DOS manual.

All DOS commands provided with the reader are available on the MS-DOS

Programs companion disk 2. The most commonly used commands are also

stored on the reader's drive D. See the README.DOC for a list of the files on

These DOS commands are not supported by the reader:

These commands are supported by the reader, but you cannot use them on

drive C or drive D because they are ROM drives:

CHKDSK (You can analyze, but not fix, drives C and D with CHKDSK.)

to execute the command. For example:

UNFORMAT.COM