Req (Request For Acknowledge) - Intermec Janus 2010 User Manual

JANUS 2010 Hand-Held Computer User's Manual
nugget

REQ (Request for Acknowledge)

Purpose: Enables or disables a request for a repeat handshake event. If you enable REQ,
you must also enable AFF and NEG to have a valid configuration.
Note: You must select the communications port and protocol before you set the
parameters that define the protocol. For help, see the "Communications Protocol,
Configure" command earlier in this chapter.
Default: Disabled
Syntax: PDdata
where data can be any ASCII character.
Scan: To disable REQ, scan this bar code:
Disable REQ
*$+PD*
*$+PD*
Or: To set REQ to an ASCII character:
1. Scan this bar code:
2. Scan a bar code for data from the "Full ASCII Bar Code Chart" in
3. Scan this bar code:
12-82
3 9
helconital
Enter Accumulate Mode / Set REQ
*+/$+PD*
*+/$+PD*
Appendix C.
Exit Accumulate Mode
*-/*
*-/*