Intermec Janus 2010 User Manual page 367

nugget
Default: All reader commands enabled
Syntax: DCdata
Acceptable values for data are:
0
1
2
3
command0
command1
The override option is a temporary setting that allows you to enable all the
reader commands for as long as you need them. When you want to return to
the previous setting, you disable the override.
Note: If you disable all the reader commands ($+DC0), you cannot change the reader's
configuration or exit from an IRL program. To enable the reader commands again, you
can use IC.EXE or edit the configuration (.INI) file.
Scan: To enable all the reader commands or override the current settings, scan one of
these bar codes:
Disable All Reader Commands
*$+DC0*
*$+DC0*
Disable Override
*$+DC2*
*$+DC2*
Or: To disable or enable specific reader commands, perform these steps:
1. Scan this bar code:
3 9
helconital
Disable all reader commands
Enable all reader commands
Disable override
Enable override
Disable reader command
Enable reader command
Enter Accumulate Mode / Command Processing
*+/$+DC*
*+/$+DC*
Configuration Command Reference
Enable All Reader Commands
*$+DC1*
*$+DC1*
Enable Override
*$+DC3*
*$+DC3*
12
12-29