Intermec Janus 2010 User Manual page 293

nugget
Operating the Reader (continued)
Problem
The reader appears to be locked up
and you cannot enter data.
The reader appears to be locked up or
q
is beeping every 10 seconds. When
you press to turn off the reader, it
does not turn off.
3 9
helconital
q
Solution
Press
next problem in this table for help. Press
the reader displays the Boot Loader menu with the message "Bad
Saved State," press
save the contents of the physical RAM drive. For help, see "Saving
the Contents of the RAM Drive" later in this chapter.
Caution
When the reader performs a cold boot, all files on the physical
RAM drive are destroyed.
Conseil
Lorsque le lecteur effectue un amorçage à froid, tous les
fichiers présents sur le lecteur de la mémoire RAM physique
sont supprimés.
q
Press
before the reader turns off. When you press
reader, it displays the Boot Loader menu.
Read the status messages at the bottom of the menu. If the messages
tell you to resume, choose Resume from the Boot Loader menu. If
the messages tell you to reboot, choose Reboot from the Boot
Loader menu to cold boot the reader. You may be able to save the
contents of the physical RAM drive. For help, see "Saving the
Contents of the RAM Drive" later in this chapter.
Caution
When the reader performs a cold boot, all files on the physical
RAM drive are destroyed.
Conseil
Lorsque le lecteur effectue un amorçage à froid, tous les
fichiers présents sur le lecteur de la mémoire RAM physique
sont supprimés.
to turn off the reader. If the reader will not turn off, see the
e
to cold boot the reader. You may be able to
5 j
- - to turn off the reader. It may take a few seconds
10
Troubleshooting
q
to turn on the reader. If
q
to turn on the
10-11