Intermec Janus 2010 User Manual page 370

JANUS 2010 Hand-Held Computer User's Manual
nugget
Command Processing (continued)
3. Scan one of these bar codes:
4. Repeat Steps 2 and 3 to disable or enable another reader command.
5. Scan this bar code:
12-32
3 9
helconital
Prepare for Reboot
*..+%*
*..+%*
Set Clock
*/+*
*/+*
Note: To disable or enable Command Override or the Enter key, see the next
section, "Disabling or Enabling Command Override and Enter."
Disable the Command
*0*
*0*
Note: You can accumulate up to 250 characters in the buffer. If the data
accumulated exceeds 250 characters, you will hear an error beep and the reader will
reject the last bar code read.
Exit Accumulate Mode
*-/*
*-/*
Reboot
*..%$*
*..%$ *
Enable the Command
*1*
*1*