Configuration Commands Listed By Category - Intermec Janus 2010 User Manual

JANUS 2010 Hand-Held Computer User's Manual
nugget

Configuration Commands Listed by Category

This chapter lists the configuration commands in alphabetical order. Use this
next list to find the configuration commands you may need to set for bar code
symbologies, communications, and operations.
Bar Code Symbologies
Codabar, 12-16
Code 11, 12-17
Code 16K, 12-18
Code 2 of 5, 12-19
Code 39, 12-21
Code 49, 12-25
Code 93, 12-27
Code 128, 12-27
Interleaved 2 of 5, 12-58
MSI, 12-72
Plessey, 12-76
UPC/EAN, 12-96
Communications
Address, Multi-Drop, 12-7
AFF (Affirmative Acknowledge), 12-8
Baud Rate, 12-11
Communications Dock Port, 12-35
Communications Port, Choose Scanner or COM2,
12-35
Communications Port, Select COM Port, 12-36
Communications Port, UART Restore, 12-37
Communications Protocol, Configure, 12-38
Communications Protocol, Activate, 12-41
Communications Protocol, Multi-Drop, User-
Defined, 12-42
12-4
3 9
helconital
Communications (continued)
Data Bits, 12-42
EOF (End of File), 12-51
EOM (End of Message), 12-52
EOR (End of Record), 12-55
Flow Control, 12-56
Intercharacter Delay, 12-57
IRL BAK (Bad Program Acknowledge), 12-61
IRL End Program Block, 12-62
IRL EOP (End of Program), 12-63
IRL PAK (Program Acknowledge), 12-64
IRL PSS (Program Statement Separator), 12-65
IRL Run, 12-66
IRL SOP (Start of Program), 12-67
LRC (Longitudinal Redundancy Check), 12-72
NEG (Negative Acknowledge), 12-74
Parity, 12-75
POL (Polling), 12-77
Records Per Block, 12-80
REQ (Request for Acknowledge), 12-82
RES (Reset), 12-83
SEL (Select), 12-89
SOM (Start of Message), 12-90
Stop Bits, 12-91
Timeout Delay, 12-92
Transmit Abort Timeout, 12-93
Turnaround Delay, 12-95