Inserting Cards Into The Type Ii Drive - Intermec Janus 2010 User Manual

Intermec janus 2010: user guide

Hide thumbs Also See for Janus 2010:

Table of Contents

Inserting Cards Into the Type II Drive

A JANUS 2010 with a PCMCIA Back has two PC card drives. The PCMCIA

Back provides a Type II PC card drive that is located on the back of the reader

on the top edge near the scanner/wand connector. You can use a Type I or

Type II PC card in the Type II drive.

To insert a PC card

1. Make sure the reader is on. Press

Note: The reader must be turned on when you insert a card into the Type II drive

or the reader may not recognize the card.

2. Hold the reader in one hand with the keypad pointed toward the floor.

With your other hand, push the PC card drive door away from the reader

until the door is released.

PC card drive door

3. Identify the two notches on the edges of the PC card. Look at the connector

end of the card. There is a single-walled notch on one side, and a double-

walled notch on the other side.

Double-walled

Connector end

Using PC Cards in the Reader

to turn on the reader.

Single-walled