If You Cannot See The Cursor; Adjusting The Display From The Dos Prompt - Intermec Janus 2010 User Manual

If You Cannot See the Cursor

If you have moved the viewport and cannot see the cursor, try entering one of
these two options:
To See the Cursor
Move the viewport to the cursor's
position. This command may not
work if you are using the reader
in Graphics mode.
Bring the cursor to the viewport.
This command does not work on
applications that have different
definitions for cursor movement
and you may erase unentered
data if you move the cursor
backward.

Adjusting the Display From the DOS Prompt

You can change several parameters to adjust the display:
• Make the screen contrast lighter or darker.
• Turn the display backlight on or off.
• Change the line at which the display scrolls.
• Change the height of the characters.
• Select automatic or manual viewport movement.
• Make the beep volume quieter or louder.
There are three ways to change these parameters:
• Use the reader's Control mode as described next.
• Use the Interactive Configuration application (IC.EXE). For help, see
Chapter 5, "Configuring the Reader."
• Use the configuration commands to change each parameter. For help, see
Chapter 12, "Configuration Command Reference."
Learning How to Use the Reader
Press These Keys Or Scan This Bar Code
f f 0
Viewport to Cursor
*/-*
*/-*
f f 5
Cursor to Viewport
*..%%*
*..%%*
2
2-27