Intermec Janus 2010 User Manual page 364

JANUS 2010 Hand-Held Computer User's Manual
nugget
Code 49 (continued)
Scan: To disable any of the function codes, scan one of these bar codes:
Disable Function Code 1
*$+CK*
*$+CK*
Disable Function Code 3
*$+CM*
*$+CM*
To set one of the function codes to a character string:
Or:
1. Scan one of these bar codes:
2. Scan any character from the "Full ASCII Bar Code Chart" in Appendix C.
3. Scan this bar code:
12-26
3 9
helconital
Enter Accumulate Mode / Set Function Code 1
*+/$+CK*
*+/$+CK*
Enter Accumulate Mode / Set Function Code 2
*+/$+CL*
*+/$+CL*
Enter Accumulate Mode / Set Function Code 3
*+/$+CM*
*+/$+CM*
You can define two characters each for Function Codes 1 and 3, and four
characters for Function Code 2.
Exit Accumulate Mode
*-/*
*-/*
Disable Function Code 2
*$+CL*
*$+CL*