Irl Pss (Program Statement Separator) - Intermec Janus 2010 User Manual

nugget

IRL PSS (Program Statement Separator)

Purpose: Separates individual IRL program statements from each other.
Note: Do not define PSS as the same character used for EOM. You must select the
communications port and protocol before you set the parameters that define the
protocol. For help, see the "Communications Protocol, Configure" command earlier in
this chapter.
Default: CR (carriage return)
Syntax: XEdata
where data can be any ASCII character.
Scan: To disable PSS, scan this bar code:
Disable PSS
*$+XE*
*$+XE*
Or: To set the PSS to an ASCII character:
1. Scan this bar code:
2. Scan a bar code for data from the "Full ASCII Bar Code Chart" in
3. Scan this bar code:
3 9
helconital
Enter Accumulate Mode / Set PSS
*+/$+XE*
*+/$+XE*
Appendix C.
Exit Accumulate Mode
*-/*
*-/*
Configuration Command Reference
12
12-65