If Your Applications Refer To Specific Drive Letters - Intermec Janus 2010 User Manual

JANUS 2010 Hand-Held Computer User's Manual
nugget
Problems With the NiCad Battery Pack (continued)
Problem
You see all these symptoms:
• The Battery icon is not displayed.
• The reader chirps every 15 seconds for
1 minute and then turns off.
• The reader double-beeps when you
enter or scan data, and double-clicks
when you press any key.
• The Backup Battery screen appears
each time you turn the reader on.

If Your Applications Refer to Specific Drive Letters

In JANUS software version 2.10, some drive letters were changed. If you are
using an application that refers to a specific drive letter on a JANUS reader
with software version 2.10 or later, you may see messages like "File Not
Found" or "Not ready reading drive X. Abort, Retry, Fail?"
You may need to change your applications if you have developed them for a
JANUS reader that has an earlier software version. The drive letter change in
software version 2.10 will only affect your applications if the application is
coded to use specific drive letters (uses an absolute path).
Note: If your applications do not use specific drive letters, you can use the applications
on a reader with software version 2.10 without making changes.
If you have JANUS readers with software version 1.31 or earlier, you may need
to change your applications if you:
• Use readers with different software versions and one of the versions is 2.10
• Upgrade all your JANUS readers to software version 2.1 or later.
10-32
3 9
helconital
Solution
The lithium backup battery is critically low.
Keep a charged NiCad battery pack installed in the reader.
You can also attach an external power supply. Save all your
data and back up all the files that are on drive E.
Contact your Intermec service representative to replace
the lithium backup battery.
or later. For example, a J2010 reader with 2.10 software and a J2010 reader
with 1.30A software.