Irl Eop (End Of Program) - Intermec Janus 2010 User Manual

nugget
3. Scan this bar code:

IRL EOP (End of Program)

Purpose: An EOP indicates the end of an IRL program block when you download a
program to the reader.
Note: You must select the communications port and protocol before you set the
parameters to define that protocol. For help, see the "Communications Protocol,
Configure" command earlier in this chapter.
SYN (synchronous idle)
Default:
Syntax: XBdata
where data can be any ASCII character.
Scan: To disable EOP, scan this bar code:
Disable EOP
*$+XB*
*$+XB*
Or: To set EOP to an ASCII character:
1. Scan this bar code:
2. Scan a bar code for data from the "Full ASCII Bar Code Chart" in
3. Scan this bar code:
3 9
helconital
Exit Accumulate Mode
*-/*
*-/*
Enter Accumulate Mode / Set EOP
*+/$+XB*
*+/$+XB*
Appendix C.
Exit Accumulate Mode
*-/*
*-/*
Configuration Command Reference
12
12-63