Exiting Screens And Saving Changes; Using A Series Of Screens To Configure A Parameter; Exiting Communications Manager - Intermec Janus 2010 User Manual

Intermec janus 2010: user guide

Hide thumbs Also See for Janus 2010:

Table of Contents

Exiting Screens and Saving Changes

When you exit a screen, you can save or discard your changes:

To exit a screen and save the changes.

To exit a screen and discard the changes.

Sometimes the Communications Manager presents a series of screens for one

parameter. You must fill in fields or select options on each screen to configure

the parameter.

For example, when you configure the User-Defined protocol for COM1,

Communications Manager displays five screens of options for the protocol.

Here are the first two screens in that series:

You can tell that a screen is part of a series when you see the Next and Prev

commands at the bottom of the screen. Next and Prev let you move forward to

the next screen or back to the previous screen.

described earlier, you press

To exit Communications Manager, select Exit from the File menu and

Communications

COM1/User-Defined

while the cursor is in any field is the same as choosing Next. As

Networking the Reader

Select OK and press

Select Cancel and press

to select the OK and Cancel buttons.

Communications

COM1/User-Defined

INTERCHARACTER:

TRANSMIT ABORT

to move to the next field in the screen.

to move to the previous field.

in any field.