JANUS 2010 Hand-Held Computer User's Manual
nugget
NEG (Negative Acknowledge)
Purpose:
Indicates a negative acknowledgment to a transmitted message. You must
enable both NEG and AFF to have a valid configuration.
Note: You must select the communications port and protocol before you set the
parameters that define the protocol. For help, see the "Communications Protocol,
Configure" command earlier in this chapter.
Default:
Disabled
Syntax:
PHdata
where data can be any ASCII character.
Scan:
To disable NEG, scan this bar code:
Disable NEG
*$+PH*
*$+PH*
Or:
To set NEG to an ASCII character:
1. Scan this bar code:
2. Scan a bar code for data from the "Full ASCII Bar Code Chart" in
3. Scan this bar code:
12-74
3 9
helconital
Enter Accumulate Mode / Set NEG
*+/$+PH*
*+/$+PH*
Appendix C.
Exit Accumulate Mode
*-/*
*-/*