Irl Program, Run; Laser On And Off - Intermec Janus 2010 User Manual

nugget

IRL Program, Run

Purpose: Runs the default IRL program {IRL-1}.IRL. For help, see "Running an IRL
Program" in Chapter 7.
Note: You can use this command only from the IRL Desktop.
From Host: //
Keypad: In the IRL Desktop, choose File and then choose Run.
Not supported
IRL Command:
Scan:
Run IRL Program
*//*
*//*

Laser On and Off

The Laser On and Off commands are the same as pulling and releasing the
scanner trigger. This command is valid on a JANUS 2010 only when you have
a laser scanner connected to the reader's scanner port.
After a Laser On command, the scanner operates differently depending on the
Scanner mode and Scanner Trigger configuration settings:
• If you configure the reader to use One-Shot Scanner mode and level
• If you configure the reader to use Automatic Scanner mode and level
Note: Intermec does not recommend that you use a Laser On or Off command with the
Scanner Trigger command set to edge triggering.
3 9
helconital
triggering, the scanner automatically turns off after a good read of a bar
code label, or after the scanner timeout period elapses.
triggering, the scanner remains on after a good read of a bar code label. You
use the Scanner Timeout command or the Laser Off command to turn off
the scanner.
Reader Command Reference
11
11-13