Attaching A Wand Or Scanner - Intermec Janus 2010 User Manual

Attaching a Wand or Scanner

To enter bar code data, you need to attach an input device to the reader. You
can use one of these Intermec input devices with the JANUS 2010:
• 1260-series, 1270-series, and 1280-series digital wands
• 146x CCD scanners
• 1500 infrared, 151x , 1545, and 155x visible laser scanners
• 1354 and 1355 badge scanners
To attach a wand or scanner to the reader
1. Turn off the reader by pressing
Caution
Attaching an input device while the reader is on could damage the reader
and/or input device.
Conseil
N'attachez pas de périphérique d'entrée pendant que le lecteur est actif car
cela pourrait endommager le lecteur et/ou le périphérique d'entrée.
2. Locate the modular connector on the top of
the reader. The connector is designed so
you can insert the input device cable only
one way. Make sure the connector snaps
into place securely.
Note: If the wand or scanner does not have a
10-pin modular connector, you can order an
adapter cable from your Intermec
representative.
3. Turn on the reader by pressing
For helpful tips on scanning bar codes, see
the wand or scanner manual.
Getting Started
.
2010U.001
.
1
1-11