Intermec Janus 2010 User Manual page 305

nugget
Using DOS Commands and Applications (continued)
Problem
You see this message when you try to
use Interlnk:
"Install Interlnk, add the following
line to your CONFIG.SYS file and
reboot..."
A DOS command does not work.
You cannot access a drive while using
Interlnk.
You do not have the MS-DOS
Programs companion disk 2 and need
to use Interlnk.
3 9
helconital
Solution
DO NOT follow the instructions in the error message.
You do not have to modify the reader's CONFIG.SYS file. Instead,
follow the instructions in "Running Interlnk to Transfer Files" in
Chapter 6.
To run Interlnk on the reader, you connect the reader to a host
computer, execute Intersvr on the host, and warm boot the reader.
The reader's default CONFIG.SYS file installs automatically when
the reader is connected to a host computer that is running Intersvr.
These DOS commands are not supported on the reader:
DOSSHELL.*
DOSSWAP.EXE
DRIVER.SYS
EGA.*
EGAMONO.GRB
FDISK.EXE
GORILLA.BAS
HERC.*
Interlnk does not redirect network drives, CD-ROM drives, or any
other device that uses a redirection interface.
These commands do not work with Interlnk:
CHKDSK
DISKCOMP
DISKCOPY
If you do not have companion disk 2, which contains the Interlnk
files, you can install Interlnk to the host from the reader.
Connect the reader and host computer with a 7-wire null modem
cable when installing Interlnk. The MODE command must be
available on the host where you are installing Interlnk.
Type this command on the reader:
intersvr /rcopy
The command copies the Interlnk files to the host computer.
Troubleshooting
MONEY.BAS
MONO.*
MSHER.COM
NIBBLE.BAS
REMLINE.BAS
UNFORMAT.COM
VGA.*
VGAMONO.GRB
FORMAT UNDELETE
MIRROR UNFORMAT
SYS
10
10-23